AbstractThe HST-XNR-400DT is a touch screen display Melt Flow Indexer that reports both MFR and MVR from one extrusion run: a 0.1-800.00 g/10min (MFR) and 0.1-800.00 cm3/10min (MVR) measuring range, a barrel from room temperature to 450deg C held at ±0.2deg C, eight gravity load grades from 0.325 tчитать Больше >>

AbstractThe HST DWC-80T is a Touch Screen display Impact Test Low Temperature Chamber built for Charpy notch impact testing of metal materials: it cools a batch of up to 72 standard impact specimens to a set point anywhere in the +30 to -80deg C range, holds it with ±0.2deg C control accuracy, and читать Больше >>

AbstractThe HST-DTQ5 is a benchtop, low-speed precision cutting machine for sectioning high-value materials - the product sheet calls out high-value artificial crystals by name. A 0-600rpm spindle, 0.01mm positioning accuracy over a 25mm mobile-frame stroke, four included clamps and a limit switch wчитать Больше >>

AbstractThe HST-SQ60 is a benchtop, manual Metallographic Cutting Machine with a 60mm maximum cutting diameter, a 2800rpm spindle and a 2.2kW drive, built to section metal and non-metal samples for metallographic and petrographic examination. With an enclosed, windowed cutting cover, an independent читать Больше >>

AbstractThe HST WDW-100E is a 100kN, four-column Double Space Electronic Universal Testing Machine with preloaded ball-screw drive, a Class 0.5 load frame (ISO 7500-1, meets ASTM E4) and three closed-loop control modes - stress, strain and displacement. It is built for laboratories that want one fraчитать Больше >>

AbstractHST NDW-2000 is a horizontal Material Torsion Testing Machine with a bidirectional measuring range of ±2000Nm and a 550mm grip clearance, driven by a servo motor through a high-precision reduction system. For laboratories that test hardware, wire and cable, fasteners, rubber and plastic parчитать Больше >>

AbstractHST-LDQ130Z is a vertical, fully enclosed Metallographic Cutting Machine built for laboratories that routinely section large or heavy workpieces - it clears a maximum passing diameter of 130mm and runs on a Siemens PLC with a 7-inch touch screen. Unlike a bench-top cutter that forces you to читать Больше >>

AbstractHigh-cycle and low-cycle fatigue behaviour decides whether a metal or rubber component survives its designed service life, so the testing machine behind that data has to hold its load accuracy across millions of cycles. This 2026 buyer's guide examines the HST-EFT10A 10kN electrodynamic dynaчитать Больше >>